Space is precious – especially when it comes to high packing densities in electrical engineering.
Space limitations mean that panel builders and switchgear manufacturers have to accommodate more and more mechanical and electrical components in enclosures.
Now, a smart new enclosure accessory from Rittal can provide far greater scope for the interior configuration of compact enclosures.
The planning and configuration of interior installations within compact enclosures can be both time-consuming and complicated.
It can also lead to actions which compromise the integrity of the enclosure and add to the cost of installation.
Additional holes often have to be drilled in areas such as the side panels to fasten components outside of the mounting plate. This not only lowers the enclosure’s protection category, it is also adds significantly to the setting-up costs.
The limited available installation space inside the enclosure can also cause problems around the best use of the existing mounting surfaces.
In response, Rittal has developed an interior installation rail.
The rail can be easily mounted to the side, floor or roof areas of the AE compact enclosure, without any need for additional drilling through the enclosure panels.
This neat solution saves time and preserves the enclosure’s protection category. It can be placed wherever it is needed in the enclosure and is easily fixed (with a screw) and it will support static loads of up to 100 N. A door-operated switch can also be fitted to the rail using an adapter (supplied).
This means that rail mounting is easy even if the mounting plate has already been installed.
The rail has two rows of system punchings to create an additional mounting surface for items such as punched sections, enclosure lights, the afore-mentioned door-operated switches, door stays, cable conduit holders and a range of other components. Use of the rail can easily double the available mounting surface inside an AE compact enclosure.
And because it has also been designed to use the accessories for the tried-and-tested modular TS 8 enclosure system, there is no longer any need to keep a duplicate stock of accessories.
More details can be found in a video here
Further information at www.rittal.co.uk and www.friedhelm-loh-group.com, or on twitter @rittal_ltd.
Watson-Marlow Fluid Technology Solutions has launched the Bredel CIP pump, designed to support hygienic and…
Process instrumentation specialist Endress+Hauser has developed a Continuous River Monitoring Solution to support UK water…
Borger UK, a leading pump manufacturer in the UK, which has firmly established itself as…
AkzoNobel Powder Coatings is strengthening support for UK powder coating businesses by expanding the capabilities…
The Challenge BakeAway is a UK-based company that has been manufacturing high-quality dough for pastry, pancakes,…
Bristol-based pump manufacturer reports record order book, major investment in UK manufacturing and wins top sustainability honour…